An original farmhouse sink under a layer of dust in the basement perhaps or a good as new cast iron tub in the master bath.
Matching original hardwood floors.
Then consider as per other comments a.
When hardwood flooring coverage is expanded it s not always necessary to sand and stain both the preexisting and newly covered areas at the same time.
Matching the new materials to the profile of the old flooring boards isn t necessary.
In such instances matching new hardwood perhaps to an addition to the home a room previously floored with carpet or tile or to a heavily damaged area is a bit more complicated but definitely worth it in most cases.
Matching an existing color is a lot harder than sanding all of it and then staining it all the same color.
Sometimes if there is not a lot of existing hardwood flooring it is just best to take up the old flooring and start from scratch.
Before beginning such a project there are a few things you will want to find out about your wood.
If matching in the middle of a big room you must finger joint with a unfinished hardwood and pretest stains prior to installation.
Thickness height of flooring and sub floor most houses in westchester have solid hardwood flooring which is 3 4 thick.
To make your floors match make sure that you install site finished hardwood floors in the new room and then refinish the old floors at the same.
You could consider first sanding back and refinishing the existing timber floors with an acrylic based finish that will be more neutral in tone and likely much easier to match in with tonally.
Instead consider having a custom mixed stain matched to the same.
This thickness known as a wood s profile should match that of the flooring in other rooms to ensure a seamless look for the viewer.
And if you re lucky original hardwood floors underneath the bad.
After the new floor is installed the profile is reduced by sanding.
When matching new hardwood floors to existing hardwood flooring in your home it is important that you purchase planks that are of a corresponding thickness to the wood floors that are already installed.
Install the other areas raw unfinished and then have it all sanded at the same time and stained to match.